As seen on the cover of Guns & Ammo magazine, this is the exact gun that was featured in the October 2001 issue of the magazine. These guns are Extremely rare, as CT (Tim) Brian does not mass produce, almost like an artist, each gun receives an enormous amount of time and painstaking detail. Almost each part is replaced with custom machined pieces made by hand. CT Brian is not accepting orders at this time and is rumored to be years behind in back log. This is a rare opportunity to not only obtain one of his guns, but also the exact one that was featured in the widely publicized Guns&Ammo magazine. Gun starts out as a Kimber Ultra Carry and then packed with Features including: Narrowed slide, Barrel throated & feed ramp properly angled and polished, Tritium Slant Pro Fixed Sights, Ejection port lowered and flared, Match grade extractor – re cut, adjusted and polished, Flush Fit hammer & grip safety, Extended tactical thumb safety, Aluminum match trigger, Trigger job (4 lbs.), Front strap checkered at 30 lines per inch, Mainspring housing contoured and checkered at 30 lines per inch. Round butt of frame, Mill flat top of slide and serrate at 40 lines per inch, Master grade bluing of slide and small parts, Hard anodizing of the frame.
Smoothed and contoured grips, Thin slot grip screws, Special Side Winder engraving. Must ship to FFL.
Condition: Unused, kept as a collectors piece. No remarkable wear. Top of chamber shows light kiss marks from test firing. Heel of butt has high edge wear.
